SYMPTOMS: Symptoms of exposure to this compound include eye irritation. Must be preheated before ignition can occur. 27°C unless otherwise stated. Inhalation of vapor or particulates can cause aspiration pneumonia. and risk. (method A and B) or ASTM D6978 test methods. It is the user's responsibility to Practically tasteless and odorless, even when warmed. Web site owner: Mineral oil, heavy or light; (paraffin oil; Deobase, deodorized; heavy paraffinic; heavy naphthenic); distillates; includes 64741-53-3, 64741-88-4, 8042-47-5, 8012-95-1; 64742-54-7. Wash any surfaces you may have contaminated with a soap and water solution. been tested at a concentration of greater than 95% unless otherwise Flash Point: 160°C: Acidity: Pass Test (NF) Identification: Pass Test (FCC/NF) Viscosity: 3 CS min. National Oceanic and Atmospheric Administration. Office of Response and Restoration, Not affected by aqueous solutions of acids, alkalis, most oxidizing agents, and most reducing agents. testing laboratories using ASTM F739, EN369, EN 374-3, EN ISO 6529 rates than the fabric. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned. This section provides a listing of alternate names for this chemical, are damaged, end user should discontinue use equipment needed. reported in minutes. A different temperature may have significant influence on the Ingestion of this compound dissolves and prevents absorption of vitamin A from intestinal contents. evaluation under their specific end-use conditions, at their own discretion When taken for 2-3 days, it can penetrate and soften stools, and may also interfere with absorption of water. The Physical Property fields include properties such as vapor pressure and boiling point, as well as explosive limits and toxic exposure thresholds The information in CAMEO Chemicals comes from a … No hazard beyond that of ordinary combustible material. Please contact DuPont for specific data. Belongs to the Following Reactive Group(s), Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher. determine the level of toxicity and the proper personal protective Serged and bound seams are degraded by some hazardous liquid additional knowledge and experience are gained. If fabric of garment to avoid potential exposure to chemical. (NTP, 1992). that the garment selected is suitable for the intended use. PHYSICAL DESCRIPTION: Transparent colorless oily liquid. of DuPont or others covering any material or its use. OIL. 【Vapor Density】 >1 including trade names and synonyms. 【Boiling Point】 300 【Density】 0.872 g/cm3 【Usage】 Lubricant, hydrolic fluid, laxative. It is subject to revision as under or a recommendation to infringe any patent or technical information SMALL SPILLS AND LEAKAGE: If you should spill this chemical, use absorbent paper to pick up all liquid spill material. temperature. Normally stable, even under fire conditions. In other settings, mostly unreactive. attached gloves, visors, etc. Unless otherwise stated, permeation was measured for single chemicals. The fabric permeation data was generated for DuPont by independent Skin: Wear appropriate personal protective clothing to prevent skin contact. This information is not intended as a license to operate Chemical warfare agents (Lewisite, Sarin, Soman, Sulfur [MINERAL] may be incompatible with strong oxidizing agents like nitric acid. this information. (NTP, 1992). The information set forth herein reflects laboratory Seal the absorbent paper, as well as any of your clothing which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Burns exothermically when heated sufficiently or when ignited in the presence of air, oxygen or strong oxidizing agents. Anyone intending to use this information should first verify performance of fabrics, not complete garments, under controlled conditions. chemicals, such as strong acids, and should not be worn when The permeation characteristics of mixtures can deviate considerably becomes torn, abraded or punctured, or if seams or closures fail, or if white mineral oil / white mineral oil (petroleum) / white mineral oil LB14-F / white mineral oil, usp/NF / white mineral oil, protol / white miniral oil CARNATION / white oil / white oil 12, 40, 68 / witco kaydol : Company identification : G-Biosciences/ Geno Technology, Inc. 9800 Page Avenue St. Louis, MO 63312-1429, USA Tel.1-800-628-7730 Normalized breakthrough times Charring may occur followed by ignition of unreacted oil and other nearby combustibles. Mineral oil (>95%) 8012-95-1: Liquid >480 >480 > indicates greater than. Mustard, Tabun and VX Nerve Agent) have been tested at 22°C and 50% Mineral oil: CAS Number: 8042-47-5: Molecular Weight: 23.9979: Density: 0.877: Boiling Point: N/A: Molecular Formula: N/A: Melting Point: N/A: MSDS: Chinese USA: Flash Point: 220 ºC × Other symptoms include lipid granuloma, lipid pneumonia, eczematous dermatitis, contact dermatitis, folliculitis, oil acne and melanosis. (FCC), 3.0 to 34.4 mm2.S-1 (NF) Boiling Point: 260°C: Physical Form: Liquid: Grade: FCC/NF: Chemical Name or Material: Mineral Oil, Light: Show More Show Less Excessive doses may result in anal seepage and irritation. these chemicals are present. Skin: If this chemical contacts the skin, wash the contaminated skin with soap and water. All chemicals have breakthrough time; permeation rates typically increase with Since conditions of use stated. (NTP, 1992), This chemical is combustible. DuPont believes to be reliable. seams and closures have shorter breakthrough times and higher permeation relative humidity per military standard MIL-STD-282. are outside our control, we make no warranties, express or implied, (the time at which the permeation rate is equal to 0.1 µg/cm2/min) In many cases, for a particular use and assume no liability in connection with any use of All liquid chemicals have been tested between approximately 20°C and National Ocean Service, It is intended for informational use by persons having technical skill for from the permeation behavior of the individual chemicals. ... in connection with this information. including, without limitation, no warranties of merchantability or fitness CAUTION: This information is based upon technical data that Lower Explosive Limit (LEL): data unavailable, Upper Explosive Limit (UEL): data unavailable, Autoignition Temperature: data unavailable, Vapor Density (Relative to Air): data unavailable, National Oceanic and Atmospheric Administration.